This adds device tree bindings for the TPO TPG110 panel found
mounted in the Nomadik NHK8815.
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
.../bindings/display/panel/tpo,tpg110.txt | 47 ++++++++++++++++++++++
1 file changed, 47 insertions(+)
create mode 100644 Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt
diff --git a/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt b/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt
new file mode 100644
index 000000000000..acbc6bef3593
--- /dev/null
+++ b/Documentation/devicetree/bindings/display/panel/tpo,tpg110.txt
@@ -0,0 +1,47 @@
+TPO TPG110 Panel
+================
+
+This binding builds on the DPI bindings, adding a few properties
+as a superset of a DPI. See panel-dpi.txt for the required DPI
+bindings.
+
+Required properties:
+- compatible : "tpo,tpg110"
+- grestb-gpio : panel reset GPIO
+- scen-gpios : serial control enable GPIO
+- scl-gpios : serial control clock line GPIO
+- sda-gpios : serial control data line GPIO
+
+Required nodes:
+- Video port for DPI input, see panel-dpi.txt
+- Panel timing for DPI setup, see panel-dpi.txt
+
+Example
+-------
+
+panel {
+ compatible = "tpo,tpg110", "panel-dpi";
+ grestb-gpios = <&stmpe_gpio44 5 GPIO_ACTIVE_LOW>;
+ scen-gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
+ scl-gpios = <&gpio0 5 GPIO_ACTIVE_HIGH>;
+ sda-gpios = <&gpio0 4 GPIO_ACTIVE_HIGH>;
+ backlight = <&bl>;
+
+ port {
+ nomadik_clcd_panel: endpoint {
+ remote-endpoint = <&nomadik_clcd_pads>;
+ };
+ };
+
+ panel-timing {
+ clock-frequency = <33200000>;
+ hactive = <800>;
+ hback-porch = <216>;
+ hfront-porch = <40>;
+ hsync-len = <1>;
+ vactive = <480>;
+ vback-porch = <35>;
+ vfront-porch = <10>;
+ vsync-len = <1>;
+ };
+};
--
2.4.3
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
