2mA drive strenght is not enough to drive chipselect low on hardware
configurations with level shifters, 16mA should give good range to
allow such configurations to work.
This issue was noticed while testing spi on db410c with sensor board.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
index 3bd917e..8d05005 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
@@ -81,8 +81,8 @@
bias-disable;
};
pinconf_cs {
- pins = "gpio2";
- drive-strength = <2>;
+ pins = "gpio16";
+ drive-strength = <16>;
bias-disable;
output-high;
};
@@ -116,7 +116,7 @@
};
pinconf_cs {
pins = "gpio6";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable;
output-high;
};
@@ -150,7 +150,7 @@
};
pinconf_cs {
pins = "gpio10";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable;
output-high;
};
@@ -184,7 +184,7 @@
};
pinconf_cs {
pins = "gpio14";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable;
output-high;
};
@@ -218,7 +218,7 @@
};
pinconf_cs {
pins = "gpio18";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable;
output-high;
};
@@ -252,7 +252,7 @@
};
pinconf_cs {
pins = "gpio22";
- drive-strength = <2>;
+ drive-strength = <16>;
bias-disable;
output-high;
};
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
