From: Alex Smith <alex.smith@xxxxxxxxxx> Add device tree nodes for the NEMC and BCH to the JZ4780 device tree, and make use of them in the Ci20 device tree to add a node for the board's NAND. Note that since the pinctrl driver is not yet upstream, this includes neither pin configuration nor busy/write-protect GPIO pins for the NAND. Use of the NAND relies on the boot loader to have left the pins configured in a usable state, which should be the case when booted from the NAND. Signed-off-by: Alex Smith <alex.smith@xxxxxxxxxx> Cc: Zubair Lutfullah Kakakhel <Zubair.Kakakhel@xxxxxxxxxx> Cc: David Woodhouse <dwmw2@xxxxxxxxxxxxx> Cc: Brian Norris <computersforpeace@xxxxxxxxx> Cc: Paul Burton <paul.burton@xxxxxxxxxx> Cc: linux-mtd@xxxxxxxxxxxxxxxxxxx Cc: devicetree@xxxxxxxxxxxxxxx Cc: linux-kernel@xxxxxxxxxxxxxxx Cc: linux-mips@xxxxxxxxxxxxxx Cc: robh@xxxxxxxxxx Signed-off-by: Harvey Hunt <harvey.hunt@xxxxxxxxxx> --- v9 -> v10: - No change. v8 -> v9: - Represent the partition table as a subnode of a NAND chip. v7 -> v8: - Describe the NAND chips as children nodes of the NAND controller. - Remove ingenic, prefix from ECC settings. - Renamed some ECC settings. v6 -> v7: - Add nand-ecc-mode to DT. - Add nand-on-flash-bbt to DT. v4 -> v5: - New patch adding DT nodes for the NAND so that the driver can be tested. arch/mips/boot/dts/ingenic/ci20.dts | 63 ++++++++++++++++++++++++++++++++++ arch/mips/boot/dts/ingenic/jz4780.dtsi | 26 ++++++++++++++ 2 files changed, 89 insertions(+) diff --git a/arch/mips/boot/dts/ingenic/ci20.dts b/arch/mips/boot/dts/ingenic/ci20.dts index 9fcb9e7..782258c 100644 --- a/arch/mips/boot/dts/ingenic/ci20.dts +++ b/arch/mips/boot/dts/ingenic/ci20.dts @@ -42,3 +42,66 @@ &uart4 { status = "okay"; }; + +&nemc { + status = "okay"; + + nandc: nand-controller@1 { + compatible = "ingenic,jz4780-nand"; + reg = <1 0 0x1000000>; + + #address-cells = <1>; + #size-cells = <0>; + + ingenic,bch-controller = <&bch>; + + ingenic,nemc-tAS = <10>; + ingenic,nemc-tAH = <5>; + ingenic,nemc-tBP = <10>; + ingenic,nemc-tAW = <15>; + ingenic,nemc-tSTRV = <100>; + + nand@1 { + reg = <1>; + + nand-ecc-step-size = <1024>; + nand-ecc-strength = <24>; + nand-ecc-mode = "hw"; + nand-on-flash-bbt; + + partitions { + #address-cells = <2>; + #size-cells = <2>; + + partition@0 { + label = "u-boot-spl"; + reg = <0x0 0x0 0x0 0x800000>; + }; + + partition@0x800000 { + label = "u-boot"; + reg = <0x0 0x800000 0x0 0x200000>; + }; + + partition@0xa00000 { + label = "u-boot-env"; + reg = <0x0 0xa00000 0x0 0x200000>; + }; + + partition@0xc00000 { + label = "boot"; + reg = <0x0 0xc00000 0x0 0x4000000>; + }; + + partition@0x8c00000 { + label = "system"; + reg = <0x0 0x4c00000 0x1 0xfb400000>; + }; + }; + }; + }; +}; + +&bch { + status = "okay"; +}; diff --git a/arch/mips/boot/dts/ingenic/jz4780.dtsi b/arch/mips/boot/dts/ingenic/jz4780.dtsi index 65389f6..b868b42 100644 --- a/arch/mips/boot/dts/ingenic/jz4780.dtsi +++ b/arch/mips/boot/dts/ingenic/jz4780.dtsi @@ -108,4 +108,30 @@ status = "disabled"; }; + + nemc: nemc@13410000 { + compatible = "ingenic,jz4780-nemc"; + reg = <0x13410000 0x10000>; + #address-cells = <2>; + #size-cells = <1>; + ranges = <1 0 0x1b000000 0x1000000 + 2 0 0x1a000000 0x1000000 + 3 0 0x19000000 0x1000000 + 4 0 0x18000000 0x1000000 + 5 0 0x17000000 0x1000000 + 6 0 0x16000000 0x1000000>; + + clocks = <&cgu JZ4780_CLK_NEMC>; + + status = "disabled"; + }; + + bch: bch@134d0000 { + compatible = "ingenic,jz4780-bch"; + reg = <0x134d0000 0x10000>; + + clocks = <&cgu JZ4780_CLK_BCH>; + + status = "disabled"; + }; }; -- 2.6.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html