The change adds fixed voltage regulator for SD controller, ARM MMCI
controller driver uses it to control card power management.
Signed-off-by: Vladimir Zapolskiy <vz@xxxxxxxxx>
---
Changes from v2 to v3:
* use "regulator" as a generic device tree node name of fixed
regulators, thanks to Sergei Shtylyov
Changes from v1 to v2:
* specify SD card power supply instead of signal power supply,
thanks to Russell King
arch/arm/boot/dts/phy3250.dts | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/arch/arm/boot/dts/phy3250.dts b/arch/arm/boot/dts/phy3250.dts
index 8ac368f..a00d7ce 100644
--- a/arch/arm/boot/dts/phy3250.dts
+++ b/arch/arm/boot/dts/phy3250.dts
@@ -45,6 +45,15 @@
enable-active-high;
regulator-boot-on;
};
+
+ sd_reg: regulator@2 {
+ compatible = "regulator-fixed";
+ regulator-name = "sd_reg";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ gpio = <&gpio 5 5 0>;
+ enable-active-high;
+ };
};
ahb {
@@ -162,6 +171,7 @@
cd-gpios = <&gpio 3 1 0>;
cd-inverted;
bus-width = <4>;
+ vmmc-supply = <&sd_reg>;
status = "okay";
};
};
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
