* Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx> [151203 10:29]: > Hello Tony, > > On 12/03/2015 03:16 PM, Tony Lindgren wrote: > > * Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx> [151203 10:03]: > >> Hello, > >> > >> This series converts the IGEPv2 (IGEP0020) and IGEP COM Module (IGEP0030) > >> Device Tree to use the MMC power sequence provider to initialize the SDIO > >> WiFi chip instead of using fake fixed regulators to just toggle the Reset > >> and Power pins in the chip. > >> > >> The patches were tested on an DM3730 IGEPv2 board but the IGEP COM Module > >> is the same with regard to the SDIO WiFi so it should be safe to land too. > >> > >> The IGEPv2 Rev.F and the IGEP COM Module Rev.G DTS were not converted due > >> using a different WiFi chip (wlcore instead of libertas) than the one in > >> the board I've access to test so I preferred to leave those untouched. > > > > Do you have some solution for the start-up latency issue? > > > > No, I don't and that's one of the reasons why I didn't want to touch the > DTS that have the wlcore chip. > > The omap3-igep0020-rev-f.dts and omap3-igep0030-rev-g.dts don't have a > startup-delay-us property in the regulator for the WLAN_EN pin as is > the case for the IGEPv5 DTS but I don't know if those DTS are just wrong. OK > The DTS for the igep0020 and igep0030 that have the libertas chip, > did have a startup-delay-us for the WIFI_PDN but using the GPIOs > for RESET_N_W and WIFI_PDN in the mmc-pwrseq-simple reset-gpios is > enough to make the SDIO chip reset, be enumerated and WiFi to work > correctly so I don't know if that is really needed or is just a bad > description in the DTS. Hmm OK. > Since is working for the boards with the libertas chip, I preferred > to remove the DTS hack but left the boards with wlcore chip since > you said the startup-delay-us is needed there (but probably we should > add to the regulators in the boards that don't have it then). OK Thanks, Tony -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
