From: Justin Waters <justin.waters@xxxxxxxxxxx> Advantech has 3 carrier boards (B450v3, B650v3, B850v3) which use the Advantech BA-16 module (based on iMX6D). This file has the devicetree entries that are common to all 3 boards. Signed-off-by: Akshay Bhat <akshay.bhat@xxxxxxxxxxx> --- arch/arm/boot/dts/imx6q-bx50v3.dtsi | 211 ++++++++++++++++++++++++++++++++++++ 1 file changed, 211 insertions(+) create mode 100644 arch/arm/boot/dts/imx6q-bx50v3.dtsi diff --git a/arch/arm/boot/dts/imx6q-bx50v3.dtsi b/arch/arm/boot/dts/imx6q-bx50v3.dtsi new file mode 100644 index 0000000..2715cd9 --- /dev/null +++ b/arch/arm/boot/dts/imx6q-bx50v3.dtsi @@ -0,0 +1,211 @@ +/* + * Copyright 2015 Timesys Corporation. + * Copyright 2015 General Electric Company + * + * The code contained herein is licensed under the GNU General Public + * License. You may obtain a copy of the GNU General Public License + * Version 2 or later at the following locations: + * + * http://www.opensource.org/licenses/gpl-license.html + * http://www.gnu.org/copyleft/gpl.html + */ + +#include "imx6q-ba16.dtsi" + +/ { + regulators { + /* regulator for wl18xx on sdhc4 */ + wl18xx_vmmc: regulator@6 { + compatible = "regulator-fixed"; + regulator-name = "vwl1807"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + gpio = <&pca9539 3 GPIO_ACTIVE_HIGH>; + startup-delay-us = <70000>; + enable-active-high; + }; + + reg_wlan: regulator@7 { + compatible = "regulator-fixed"; + regulator-name = "3P3V_wlan"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + regulator-always-on; + regulator-boot-on; + gpio = <&gpio6 14 GPIO_ACTIVE_HIGH>; + }; + }; + + sound { + compatible = "fsl,imx6q-ba16-sgtl5000", + "fsl,imx-audio-sgtl5000"; + model = "imx6q-ba16-sgtl5000"; + ssi-controller = <&ssi1>; + audio-codec = <&codec>; + audio-routing = + "MIC_IN", "Mic Jack", + "Mic Jack", "Mic Bias", + "LINE_IN", "Line In Jack", + "Headphone Jack", "HP_OUT"; + mux-int-port = <1>; + mux-ext-port = <4>; + }; + + clocks { + #address-cells = <1>; + #size-cells = <0>; + mclk: clock@0 { + compatible = "fixed-clock"; + reg = <0>; + #clock-cells = <0>; + clock-frequency = <22000000>; + }; + }; +}; + +&i2c1 { + pca9547: mux@70 { + compatible = "nxp,pca9547"; + reg = <0x70>; + #address-cells = <1>; + #size-cells = <0>; + + mux_i2c3: i2c@0 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x0>; + + ads7830: ads7830@48 { + compatible = "ti,ads7830"; + reg = <0x48>; + }; + + mma8453: mma8453@1c { + compatible = "fsl,mma8453"; + reg = <0x1c>; + }; + }; + + mux_i2c4: i2c@1 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x1>; + + eeprom: eeprom@50 { + compatible = "atmel,24c08"; + reg = <0x50>; + }; + + mpl3115: mpl3115@60 { + compatible = "fsl,mpl3115"; + reg = <0x60>; + }; + }; + + mux_i2c5: i2c@2 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x2>; + }; + + mux_i2c6: i2c@3 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x3>; + + codec: sgtl5000@0a { + compatible = "fsl,sgtl5000"; + reg = <0x0a>; + clocks = <&mclk>; + VDDA-supply = <®_1p8v>; + VDDIO-supply = <®_3p3v>; + }; + }; + + mux_i2c7: i2c@4 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x4>; + + pca9539: pca9539@74 { + compatible = "nxp,pca9539"; + reg = <0x74>; + gpio-controller; + #gpio-cells = <2>; + interrupt-controller; + interrupt-parent = <&gpio2>; + interrupts = <3 IRQ_TYPE_LEVEL_LOW>; + }; + }; + + mux_i2c8: i2c@5 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x5>; + + igb@49 { + compatible = "intel,igb"; + reg = <0x49>; + }; + + igb@61 { + compatible = "intel,igb"; + reg = <0x61>; + }; + }; + + mux_i2c9: i2c@6 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x6>; + }; + + mux_i2c10: i2c@7 { + #address-cells = <1>; + #size-cells = <0>; + reg = <0x7>; + }; + }; +}; + + +&usdhc4 { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usdhc4>; + bus-width = <4>; + vmmc-supply = <&wl18xx_vmmc>; + no-1-8-v; + non-removable; + enable-sdio-wakeup; + keep-power-in-suspend; + cap-power-off-card; + max-frequency = <25000000>; + status = "okay"; + + #address-cells = <1>; + #size-cells = <0>; + wlcore: wlcore@0 { + compatible = "ti,wl1837"; + reg = <2>; + interrupt-parent = <&gpio2>; + interrupts = <6 IRQ_TYPE_LEVEL_HIGH>; + tcxo-clock-frequency = <26000000>; + }; +}; + +&ecspi5 { + fsl,spi-num-chipselects = <1>; + cs-gpios = <&gpio1 17 GPIO_ACTIVE_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_ecspi5>; + status = "okay"; + + m25_eeprom: m25p80@0 { + compatible = "atmel,at25"; + spi-max-frequency = <20000000>; + size = <0x8000>; + pagesize = <64>; + reg = <0>; + address-width = <16>; + }; +}; -- 2.6.3 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
