Hi Markus, Thank you for the patch. On Friday 06 November 2015 14:13:44 Markus Pargmann wrote: > The power_on function of the driver resets the chip and sets the > CHIP_CONTROL register to 0. This switches the operating mode to slave. > The s_stream function sets the correct mode. But this caused problems on > a board where the camera chip is operated as master. The camera started > after a random amount of time streaming an image, I observed between 10 > and 300 seconds. > > The STRFM_OUT and STLN_OUT pins are not connected on this board which > may cause some issues in slave mode. I could not find any documentation > about this. > > Keeping the chip in master mode after the reset helped to fix this > issue for me. > > Signed-off-by: Markus Pargmann <mpa@xxxxxxxxxxxxxx> > --- > drivers/media/i2c/mt9v032.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/drivers/media/i2c/mt9v032.c b/drivers/media/i2c/mt9v032.c > index 4aefde9634f5..943c3f39ea73 100644 > --- a/drivers/media/i2c/mt9v032.c > +++ b/drivers/media/i2c/mt9v032.c > @@ -344,7 +344,8 @@ static int mt9v032_power_on(struct mt9v032 *mt9v032) > if (ret < 0) > return ret; > > - return regmap_write(map, MT9V032_CHIP_CONTROL, 0); > + return regmap_write(map, MT9V032_CHIP_CONTROL, > + MT9V032_CHIP_CONTROL_MASTER_MODE); This makes sense, but shouldn't you also fix the mt9v032_s_stream() function then ? It clears the MT9V032_CHIP_CONTROL_MASTER_MODE bit when turning the stream off. > } > > static void mt9v032_power_off(struct mt9v032 *mt9v032) -- Regards, Laurent Pinchart -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
