Re: [PATCH 2/2] watchdog: s3c2410_wdt: use syscon regmap interface to configure pmu register

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 30 October 2013 12:23, Leela Krishna Amudala <l.krishna@xxxxxxxxxxx> wrote:
> The syscon regmap interface is used to configure AUTOMATIC_WDT_RESET_DISABLE
> and MASK_WDT_RESET_REQUEST registers of PMU to mask/unmask enable/disable of
> watchdog in probe and s2r scenarios.
>
> Signed-off-by: Leela Krishna Amudala <l.krishna@xxxxxxxxxxx>
> ---
>  .../devicetree/bindings/watchdog/samsung-wdt.txt   |   13 ++-
>  drivers/watchdog/s3c2410_wdt.c                     |  114 ++++++++++++++++++--
>  2 files changed, 118 insertions(+), 9 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/watchdog/samsung-wdt.txt b/Documentation/devicetree/bindings/watchdog/samsung-wdt.txt
> index 2aa486c..c46c7ce 100644
> --- a/Documentation/devicetree/bindings/watchdog/samsung-wdt.txt
> +++ b/Documentation/devicetree/bindings/watchdog/samsung-wdt.txt
> @@ -5,10 +5,21 @@ after a preset amount of time during which the WDT reset event has not
>  occurred.
>
>  Required properties:
> -- compatible : should be "samsung,s3c2410-wdt"
> +- compatible : should be "samsung,s3c2410-wdt" or "samsung,s3c5250-wdt" or "samsung,s3c5420-wdt"

This should be written as "should be one among the following:
                (a) "samsung,s3c2410-wdt" for xyz SoC
                (b) ....
                (c) ...

>  - reg : base physical address of the controller and length of memory mapped
>         region.
>  - interrupts : interrupt number to the cpu.
> +- samsung,pmusysreg : reference node to pmu sysreg (required only in case of Exynos5250 and 5420)

This property is samsung,sysreg.

>
>  Optional properties:
>  - timeout-sec : contains the watchdog timeout in seconds.
> +
> +watchdog@101D0000 {
> +       compatible = "samsung,s3c5250-wdt";
> +       reg = <0x101D0000 0x100>;
> +       interrupts = <0 42 0>;
> +       clocks = <&clock 336>;
> +       clock-names = "watchdog";
> +       samsung,sysreg = <&pmu_sys_reg>;
> +       status = "okay";
> +};
> diff --git a/drivers/watchdog/s3c2410_wdt.c b/drivers/watchdog/s3c2410_wdt.c
> index 23aad7c..2a3429c 100644
> --- a/drivers/watchdog/s3c2410_wdt.c
> +++ b/drivers/watchdog/s3c2410_wdt.c
> @@ -41,6 +41,8 @@
>  #include <linux/slab.h>
>  #include <linux/err.h>
>  #include <linux/of.h>
> +#include <linux/mfd/syscon.h>
> +#include <linux/regmap.h>
>
>  #define S3C2410_WTCON          0x00
>  #define S3C2410_WTDAT          0x04
> @@ -61,6 +63,10 @@
>  #define CONFIG_S3C2410_WATCHDOG_ATBOOT         (0)
>  #define CONFIG_S3C2410_WATCHDOG_DEFAULT_TIME   (15)
>
> +#define WDT_DISABLE_REG_OFFSET         0x0408
> +#define WDT_MASK_RESET_REG_OFFSET      0x040c
> +#define QUIRK_NEEDS_PMU_CONFIG         (1 << 0)
> +
>  static bool nowayout   = WATCHDOG_NOWAYOUT;
>  static int tmr_margin;
>  static int tmr_atboot  = CONFIG_S3C2410_WATCHDOG_ATBOOT;
> @@ -84,6 +90,12 @@ MODULE_PARM_DESC(soft_noboot, "Watchdog action, set to 1 to ignore reboots, "
>                         "0 to reboot (default 0)");
>  MODULE_PARM_DESC(debug, "Watchdog debug, set to >1 for debug (default 0)");
>
> +struct pmu_config {
> +       int     disable_reg;
> +       int     mask_reset_reg;
> +       int     mask_bit;
> +};
> +
>  struct s3c2410_wdt {
>         struct device           *dev;
>         struct clk              *clock;
> @@ -94,7 +106,34 @@ struct s3c2410_wdt {
>         unsigned long           wtdat_save;
>         struct watchdog_device  wdt_device;
>         struct notifier_block   freq_transition;
> +       struct pmu_config       *wdt_pmu_config;
> +       struct regmap           *pmureg;
> +       unsigned int            quirks;
> +};
> +
> +static struct pmu_config pmu_config_5250  = {
> +       .disable_reg = WDT_DISABLE_REG_OFFSET,
> +       .mask_reset_reg = WDT_MASK_RESET_REG_OFFSET,
> +       .mask_bit = 20
> +};
> +
> +static struct pmu_config pmu_config_5420 = {
> +       .disable_reg = WDT_DISABLE_REG_OFFSET,
> +       .mask_reset_reg = WDT_MASK_RESET_REG_OFFSET,
> +       .mask_bit = 0
> +};
> +

The above 2 structures could also be under ifdef CONFIG_OF

> +#ifdef CONFIG_OF
> +static const struct of_device_id s3c2410_wdt_match[] = {
> +       { .compatible = "samsung,s3c2410-wdt" },
> +       { .compatible = "samsung,s3c5250-wdt",
> +         .data = (struct pmu_config *) &pmu_config_5250 },
> +       { .compatible = "samsung,s3c5420-wdt",
> +         .data = (struct pmu_config *) &pmu_config_5420 },
> +       {},
>  };
> +MODULE_DEVICE_TABLE(of, s3c2410_wdt_match);
> +#endif
>
>  /* watchdog control routines */
>
> @@ -111,6 +150,40 @@ static inline struct s3c2410_wdt *freq_to_wdt(struct notifier_block *nb)
>         return container_of(nb, struct s3c2410_wdt, freq_transition);
>  }
>
> +static void s3c2410wdt_mask_and_disable_reset(int mask, struct s3c2410_wdt *wdt)
> +{
> +       unsigned int disable, mask_reset;
> +       int ret;
> +
> +       ret = regmap_read(wdt->pmureg, wdt->wdt_pmu_config->disable_reg,
> +                                                               &disable);
> +       if (ret < 0) {
> +               dev_err(wdt->dev, "%s:%d fail to read disable reg(%d)\n",
> +                               __func__, __LINE__, ret);

func and LINE does not add much value. Could be dropped.

> +               return;
> +       }
> +
> +       ret = regmap_read(wdt->pmureg, wdt->wdt_pmu_config->mask_reset_reg,
> +                                                               &mask_reset);
> +       if (ret < 0) {
> +               dev_err(wdt->dev, "%s:%d fail to read mask reset reg(%d)\n",
> +                               __func__, __LINE__, ret);

ditto

-- 
With warm regards,
Sachin
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux