We enable NAND support for Broadcom NS2 SoC by reusing existing BRCMNAND driver. This patchset applies on-top of "arm64: Simple additions to NS2 DT" v1 patchset and is available in ns2_nand_v5 branch of https://github.com/Broadcom/arm64-linux.git. The patchset is tested on NS2 SVK. Changes since v4: - Fix accidental typo in patch2 regarding use of CFG_BUS_WIDTH Changes since v3: - Include Brian's patch for magic number cleanup related to CFG and CFG_EXT registers - Base patch1 of v3 patchset upon Brian's cleanup patch Changes since v2: - Dropped patch1 and patch2 because these are already merged by MTD maintainer. - Avoid using absolute node paths in ns2-svk.dts. Changes since v1: - Dropped patch3 and patch4 because we don't need to reset BRCMNAND controller for NS2. - Added patch to force 8bit mode before doing nand_scan_ident() in brcmnand_init_cs(). Anup Patel (2): mtd: brcmnand: Force 8bit mode before doing nand_scan_ident() arm64: dts: Add BRCM IPROC NAND DT node for NS2 Brian Norris (1): mtd: brcmnand: factor out CFG and CFG_EXT bitfields arch/arm64/boot/dts/broadcom/ns2-svk.dts | 30 +++++++++++++------- arch/arm64/boot/dts/broadcom/ns2.dtsi | 14 ++++++++++ drivers/mtd/nand/brcmnand/brcmnand.c | 48 +++++++++++++++++++++++++++----- 3 files changed, 75 insertions(+), 17 deletions(-) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html