Thanks Stephen, On 23/09/13 21:40, Stephen Warren wrote: > On 09/19/2013 02:59 AM, Srinivas KANDAGATLA wrote: >> This patch adds support to ST RC driver, which is basically a IR/UHF >> receiver and transmitter. This IP (IRB) is common across all the ST >> parts for settop box platforms. IRB is embedded in ST COMMS IP block. >> It supports both Rx & Tx functionality. >> >> In this driver adds only Rx functionality via LIRC codec. > >> diff --git a/Documentation/devicetree/bindings/media/st-rc.txt b/Documentation/devicetree/bindings/media/st-rc.txt > >> +Required properties: >> + - compatible: should contain "st,comms-irb". >> + - reg: base physical address of the controller and length of memory >> + mapped region. > > Nits: > > The indentation is a little odd here; I'd expect the - to be in column > 1, at least that's how most other binding docs are written. Not a big > deal though. > > It'd be nice to indent the continuation lines (e.g. "mapped region") a > bit more so it's easier to see where each new entry starts. > > There are two spaces in "mapped region". I should have noticed it... I will fix it in next version. > >> + - rx-mode: can be "infrared" or "uhf". rx-mode should be present iff the >> + rx pins are wired up. >> + - tx-mode: should be "infrared". tx-mode should be present iff the tx >> + pins are wired up. > > Should those property names be prefixed with "st,"; I assume they're > specific to this binding rather than something generic that applies to > all IR controller bindings? If you expect them to be generic, it's fine. Officially these bindings are not specified in ePAPR specs but I see no reason for not having these properties as generic ones. Are you ok with that? > >> + - clocks : phandle with clock-specifier pair. > > For what clock? Its Clock for IRB block. I will add this in next version. > > Thanks, srini -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html