Use a firmware operation to set the CPU reset handler and only resort to doing it ourselves if there is none defined. This supports the booting of secondary CPUs on devices using a TrustZone secure monitor. Signed-off-by: Alexandre Courbot <acourbot@xxxxxxxxxx> --- arch/arm/mach-tegra/reset.c | 17 ++++++++++++++--- 1 file changed, 14 insertions(+), 3 deletions(-) diff --git a/arch/arm/mach-tegra/reset.c b/arch/arm/mach-tegra/reset.c index 6964117..fc9cf03 100644 --- a/arch/arm/mach-tegra/reset.c +++ b/arch/arm/mach-tegra/reset.c @@ -21,6 +21,7 @@ #include <asm/cacheflush.h> #include <asm/hardware/cache-l2x0.h> +#include <asm/firmware.h> #include "iomap.h" #include "irammap.h" @@ -65,6 +66,7 @@ static void __init tegra_cpu_reset_handler_enable(void) void __iomem *iram_base = IO_ADDRESS(TEGRA_IRAM_RESET_BASE); const u32 reset_address = TEGRA_IRAM_RESET_BASE + tegra_cpu_reset_handler_offset; + int err; BUG_ON(is_enabled); BUG_ON(tegra_cpu_reset_handler_size > TEGRA_IRAM_RESET_HANDLER_SIZE); @@ -72,9 +74,18 @@ static void __init tegra_cpu_reset_handler_enable(void) memcpy(iram_base, (void *)__tegra_cpu_reset_handler_start, tegra_cpu_reset_handler_size); - tegra_cpu_reset_handler_set(reset_address); - - is_enabled = true; + err = call_firmware_op(set_cpu_boot_addr, 0, reset_address); + switch (err) { + case -ENOSYS: + tegra_cpu_reset_handler_set(reset_address); + /* pass-through */ + case 0: + is_enabled = true; + break; + default: + pr_crit("Cannot set CPU reset handler: %d\n", err); + BUG(); + } } void __init tegra_cpu_reset_handler_init(void) -- 1.8.4 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html