Hello, This patch series adds support for the remaining devices (or device options) not yet supported in dt. AFAICT there is no more infos/devices not converted to dt for this board, and we should be able to remove board-at91rm9200ek.c (when we decide to do it). This series was not tested (the dt compilation passed), could someone owning this board test it ? In order to test it, you need to apply these series first: https://lkml.org/lkml/2013/8/27/58 pinctrl: at91: add support for OUTPUT config Best Regards, Boris Boris BREZILLON (9): ARM: at91/dt: rm9200: add spi0 chip select pins definitions ARM: at91/dt: add ethernet phy to at91rm9200ek board ARM: at91/dt: add usb1 vbus and pullup pins ARM: at91/dt: add atmel,pullup-gpio to at91rm9200ek usb1 definition ARM: at91/dt: add mmc0 slot0 support to at91rm9200ek board ARM: at91/dt: add spi0 support to at91rm9200ek board ARM: at91/dt: add i2c devices connected to at91rm9200ek board ARM: at91/dt: add new at91rm9200ek_mmc board ARM: at91/dt: add new at91rm9200ek_dataflash board arch/arm/boot/dts/at91rm9200.dtsi | 20 ++++++ arch/arm/boot/dts/at91rm9200ek.dts | 88 ++++++++++++++++++++++++++ arch/arm/boot/dts/at91rm9200ek_dataflash.dts | 33 ++++++++++ arch/arm/boot/dts/at91rm9200ek_mmc.dts | 23 +++++++ 4 files changed, 164 insertions(+) create mode 100644 arch/arm/boot/dts/at91rm9200ek_dataflash.dts create mode 100644 arch/arm/boot/dts/at91rm9200ek_mmc.dts -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
