Hi,
On 08/07/2013 06:53 AM, Fabian Vogt wrote:
This driver supports the GPIO controller found in LSI ZEVIO SoCs.
It has been successfully tested on a TI nspire CX calculator.
diff --git a/Documentation/devicetree/bindings/gpio/gpio-zevio.txt
b/Documentation/devicetree/bindings/gpio/gpio-zevio.txt
+Zevio GPIO controller
+
+Required properties:
+- compatible = "lsi,zevio-gpio"
Is there only one zevio chip, or a series? Is "zevio" the full name of
the chip, including any version number?
We don't know, it's a relableled chip with
TI-NSPIRE / L9A0702 / TI-NS2006A-0 / LSI LOGIC / ZEVIO / U 0714 /
WYJ14052-1
on it. But this driver should match the other drivers (lsi,zevio-intc,
lsi,zevio-timer).
+- reg = <BASEADDR SIZE>
+- #gpio-cells = <2>
+- gpio-controller;
+
+Optional:
+- #ngpios = <32>: Number of GPIOs. Defaults to 32 if absent
Perhaps one can derive that from the compatible value? The fact this
property exists implies there's more than one zevio chip, so perhaps
each should have an explicit compatible value described above?
I added it just for someone who maybe needs it. It's only two lines and
maybe
it'll be helpful for someone. We don't know whether some similiar or this
controller
exist in different configurations (pin count, section sice, register
layout).
Also I hate hardcoded values which require a recompile to change..
Is the GPIO block not also an interrupt source/controller? I see the
following in the patch, and references to some IRQ registers...
+ select GENERIC_IRQ_CHIP
I forgot to remove this line after testing the interrupts, the tests went
horribly (hard lockups)...
V4 should be underway soon.
Bye,
Fabian
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
