On 08/23/2013 03:10 AM, Thierry Reding wrote:
> On Wed, Aug 21, 2013 at 11:07:42AM +0800, Xiubo Li wrote:
>> Signed-off-by: Xiubo Li <Li.Xiubo@xxxxxxxxxxxxx> ---
>> .../devicetree/bindings/pwm/fsl-ftm-pwm.txt | 52
>> ++++++++++++++++++++++ 1 file changed, 52 insertions(+) create
>> mode 100644
>> Documentation/devicetree/bindings/pwm/fsl-ftm-pwm.txt
>> diff --git
>> a/Documentation/devicetree/bindings/pwm/fsl-ftm-pwm.txt
>> b/Documentation/devicetree/bindings/pwm/fsl-ftm-pwm.txt
>> +Required properties: +- compatible: should be
>> "fsl,vf610-ftm-pwm" +- reg: physical base address and length of
>> the controller's registers +- #pwm-cells: Should be 3. Number of
>> cells being used to specify PWM property. + First cell specifies
>> the per-chip channel index of the PWM to use, the + second cell
>> is the period in nanoseconds and bit 0 in the third cell is +
>> used to encode the polarity of PWM output. Set bit 0 of the third
>> in PWM + specifier to 1 for inverse polarity & set to 0 for
>> normal polarity.
Lines 2..n of a property description should be indented so it's easier
to see where each entry in the list starts.
>> +- fsl,pwm-clk-ps: the ftm0 pwm clock's prescaler, divide-by
>> 2^n(n = 0 ~ 7). +- fsl,pwm-cpwm: Center-Aligned PWM (CPWM) mode.
>> +- fsl,pwm-number: the number of PWM devices, and is must equal
>> to the number + of "fsl,pwm-channels".
Isn't that value a static facet of the HW, and hence it can be
determined solely from the compatible value?
>> +- fsl,pwm-channels: the channels' order which is be used for pwm
>> in ftm0 + module, and they must be one or some of 0 ~ 7, because
>> the ftm0 only has + 8 channels can be used.
Why is there a need to re-order the channels? Why not simply reference
the actual physical channel IDs in client nodes?
>> +- for very channel, the revlatived the pinctrl should be at
>> least two state + {"enN", "dsN"}, which "en" means "enable",
>> "ds" means "disable" and "N" + means the order of the channel.
revlatived??
Why is there a need for pinctrl interaction at all?
Is the "N" in these property names the index into fsl,pwm-channels, or
the physical channel number in the controller HW, or something else?
"dis" would be better than "ds", although "enable-chN", "disable-chN"
would be even better.
Note that it's not possible to enable multiple pinctrl states at once,
so what happens when channel 0 is enabled, yet channel 1 is disabled,
and you want to enable "en0" and "ds1" at the same time?
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
