On 08/14/2013 10:14 AM, Alan Stern wrote: > On Wed, 14 Aug 2013, Mark Brown wrote: > >> On Wed, Aug 14, 2013 at 10:27:26AM -0400, Alan Stern wrote: >>> On Wed, 14 Aug 2013, Mark Brown wrote: >> >>>> I'd expect that we're just looking at hooks around connection and >>>> disconnection here here - if we're looking at much more it seems like we >>>> must be doing something wrong. >> >>> Connection and disconnection of what? >> >> The device on the bus. >> >>> In the example mentioned earlier, the GPIOs to power an on-board USB >>> hub would have to be initialized when the host controller was started. >>> You wouldn't want to wait for the on-board hub to be detected, because >>> without those GPIOs set properly, it never would be discovered on the >>> USB bus. Right? >> >> Yes, so you'd want callbacks when the device actually appears and >> disappears. > > No, no -- this is exactly the point I was trying to make. The on-board > hub _won't_ appear on the USB bus until the GPIOs are set. Therefore > the callback to set the GPIOs needs to be at a different place, not > when the device appears. The device Mark was talking about is the controller end of the bus (EHCI controller, or hub's downstream port) not the device end of the bus (any USB device's upstream port). -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html