Hi,
Shawn Guo wrote:
> On Mon, Dec 16, 2013 at 04:14:10PM -0500, Anson Huang wrote:
> > on i.MX6Q, cpu freq change need to follow below flows:
> >
> > 1. each setpoint has different VDDARM, VDDSOC/PU voltage, get the setpoint
> > table from dts;
> > 2. when cpu freq is scaling up, need to increase VDDSOC/PU voltage before
> > VDDARM, if VDDPU is off, no need to change it;
> > 3. when cpu freq is scaling down, need to decrease VDDARM voltage before
> > VDDSOC/PU, if VDDPU is off, no need to change it;
> >
> > Signed-off-by: Anson Huang <b20788@xxxxxxxxxxxxx>
> > ---
[...]
> > + if (soc_opp_index >= soc_opp_count) {
>
> Can soc_opp_index be possibly greater than soc_opp_count? Otherwise,
> the condition check below is good enough?
>
> if (soc_opp_index == soc_opp_count)
>
it doen't harm to be on the safe side and use >= anyway!
Lothar Waßmann
--
___________________________________________________________
Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996
www.karo-electronics.de | info@xxxxxxxxxxxxxxxxxxx
___________________________________________________________
--
To unsubscribe from this list: send the line "unsubscribe cpufreq" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
