On 07/31/2013 10:28 AM, Sudeep KarkadaNagesha wrote:
On 31/07/13 15:46, Nishanth Menon wrote:
On 07/31/2013 06:14 AM, Sudeep KarkadaNagesha wrote:
On 30/07/13 21:48, Nishanth Menon wrote:
[...]
This should setup stage for many of the work we have been trying to
figure out on AM/OMAP and few other processors which has to depend on
few sets of OPPs which may not be supported on various platforms.
I still don't get the point why you would publish some OPP in the DT
when the hardware which it describes doesn't support it.
This may be already discussed when DT support was added to OPP library,
IMO if for some reason the firmware/boot entity disables some of the
OPPs, then it can append OPPs in DT with the state(enabled/disabled).
But this needs extension of current binding.
you could also have reduced OPP set which needs to be invoked, appending
wont really work if cpufreq table is built as part of probe - it kind of
creates all kind of races which I would really like to avoid.
IIUC opp_set_availability(opp_enable/opp_disable) is designed for such
use-case ? Currently there are no users of this API but I see it fits
your use case.
Even with multiple OPP sets listed in DT as you described, you need to
read those fuses and chose the right set of OPPs. Instead you can use
opp_en(/dis)able methods to do that ?
yes when the efuse data is present, but look at the other case I had
also pointed at:
Lets take an example: SoC X has OPPs 1,2,3,4
Same SoC is used on Board A and B.
Board A meets with all SoC vendor requirements for routing, IR drop
limits etc
Board B *does not* meet with all SoC vendor requirements for routing, IR
drop limits etc
we no longer have board files, board will have to have a mechanism to
"state it is not optimal configuration".
A real life example is BeagleBoard Xm and another product board(which I
cannot mention) -both use OMAP3630 1GHz part. 1GHz requirements are met
on BeagleBoard Xm, but on the product board it is not. Chip used is
exactly the same, we dont have "dts property" to mention "yes, this
board meets SoC data manual and associated documentation requirement" -
instead what we do have is what is the chip capable of doing.
opp_enable/disable wont work here unless there is board specific
"properties" we introduce. However, board file could choose "low
performance" option of OPPs.
the opp_enable/disable wont scale there. Further, opp_add is done
enmasse by cpufreq-cpu0 and and cpufreq table is built off it, there is
no option of SoC specific modification to the table (opportunity to do
opp_enable/disable) there - not something that cannot be fixed, and
eventually will be, but not there right now.
--
Regards,
Nishanth Menon
--
To unsubscribe from this list: send the line "unsubscribe cpufreq" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
