[PATCH v3 1/3] cpufreq: ondemand: Change the calculation of target frequency

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Ondemand calculates load in terms of frequency and increases it only
if the load_freq is greater than up_threshold multiplied by current
or average frequency. This seems to produce oscillations of frequency
between min and max because, for example, a relatively small load can
easily saturate minimum frequency and lead the CPU to max. Then, the
CPU will decrease back to min due to a small load_freq.

This patch changes the calculation method of load and target frequency
considering 2 points:
- Load computation should be independent from current or average
measured frequency. For example an absolute load 80% at 100MHz is not
necessarily equivalent to 8% at 1000MHz in the next sampling interval.
- Target frequency should be increased to any value of frequency table
proportional to absolute load, instead to only the max. Thus:

Target frequency = C * load

where C = policy->cpuinfo.max_freq / 100

Tested on Intel i7-3770 CPU @ 3.40GHz and on Quad core 1500MHz Krait.
Phoronix benchmark of Linux Kernel Compilation 3.1 test shows an
increase ~1.5% in performance. cpufreq_stats (time_in_state) shows
that middle frequencies are used more, with this patch. Highest
and lowest frequencies were used less by ~9%

Signed-off-by: Stratos Karafotis <stratosk@xxxxxxxxxxxx>
---
 drivers/cpufreq/cpufreq_governor.c | 10 +---------
 drivers/cpufreq/cpufreq_governor.h |  1 -
 drivers/cpufreq/cpufreq_ondemand.c | 39 +++++++-------------------------------
 3 files changed, 8 insertions(+), 42 deletions(-)

diff --git a/drivers/cpufreq/cpufreq_governor.c b/drivers/cpufreq/cpufreq_governor.c
index a849b2d..47c8077 100644
--- a/drivers/cpufreq/cpufreq_governor.c
+++ b/drivers/cpufreq/cpufreq_governor.c
@@ -54,7 +54,7 @@ void dbs_check_cpu(struct dbs_data *dbs_data, int cpu)
 
 	policy = cdbs->cur_policy;
 
-	/* Get Absolute Load (in terms of freq for ondemand gov) */
+	/* Get Absolute Load */
 	for_each_cpu(j, policy->cpus) {
 		struct cpu_dbs_common_info *j_cdbs;
 		u64 cur_wall_time, cur_idle_time;
@@ -105,14 +105,6 @@ void dbs_check_cpu(struct dbs_data *dbs_data, int cpu)
 
 		load = 100 * (wall_time - idle_time) / wall_time;
 
-		if (dbs_data->cdata->governor == GOV_ONDEMAND) {
-			int freq_avg = __cpufreq_driver_getavg(policy, j);
-			if (freq_avg <= 0)
-				freq_avg = policy->cur;
-
-			load *= freq_avg;
-		}
-
 		if (load > max_load)
 			max_load = load;
 	}
diff --git a/drivers/cpufreq/cpufreq_governor.h b/drivers/cpufreq/cpufreq_governor.h
index e7bbf76..c305cad 100644
--- a/drivers/cpufreq/cpufreq_governor.h
+++ b/drivers/cpufreq/cpufreq_governor.h
@@ -169,7 +169,6 @@ struct od_dbs_tuners {
 	unsigned int sampling_rate;
 	unsigned int sampling_down_factor;
 	unsigned int up_threshold;
-	unsigned int adj_up_threshold;
 	unsigned int powersave_bias;
 	unsigned int io_is_busy;
 };
diff --git a/drivers/cpufreq/cpufreq_ondemand.c b/drivers/cpufreq/cpufreq_ondemand.c
index 4b9bb5d..62e67a9 100644
--- a/drivers/cpufreq/cpufreq_ondemand.c
+++ b/drivers/cpufreq/cpufreq_ondemand.c
@@ -29,11 +29,9 @@
 #include "cpufreq_governor.h"
 
 /* On-demand governor macros */
-#define DEF_FREQUENCY_DOWN_DIFFERENTIAL		(10)
 #define DEF_FREQUENCY_UP_THRESHOLD		(80)
 #define DEF_SAMPLING_DOWN_FACTOR		(1)
 #define MAX_SAMPLING_DOWN_FACTOR		(100000)
-#define MICRO_FREQUENCY_DOWN_DIFFERENTIAL	(3)
 #define MICRO_FREQUENCY_UP_THRESHOLD		(95)
 #define MICRO_FREQUENCY_MIN_SAMPLE_RATE		(10000)
 #define MIN_FREQUENCY_UP_THRESHOLD		(11)
@@ -159,14 +157,10 @@ static void dbs_freq_increase(struct cpufreq_policy *p, unsigned int freq)
 
 /*
  * Every sampling_rate, we check, if current idle time is less than 20%
- * (default), then we try to increase frequency. Every sampling_rate, we look
- * for the lowest frequency which can sustain the load while keeping idle time
- * over 30%. If such a frequency exist, we try to decrease to this frequency.
- *
- * Any frequency increase takes it to the maximum frequency. Frequency reduction
- * happens at minimum steps of 5% (default) of current frequency
+ * (default), then we try to increase frequency. Else, we adjust the frequency
+ * proportional to load.
  */
-static void od_check_cpu(int cpu, unsigned int load_freq)
+static void od_check_cpu(int cpu, unsigned int load)
 {
 	struct od_cpu_dbs_info_s *dbs_info = &per_cpu(od_cpu_dbs_info, cpu);
 	struct cpufreq_policy *policy = dbs_info->cdbs.cur_policy;
@@ -176,29 +170,17 @@ static void od_check_cpu(int cpu, unsigned int load_freq)
 	dbs_info->freq_lo = 0;
 
 	/* Check for frequency increase */
-	if (load_freq > od_tuners->up_threshold * policy->cur) {
+	if (load > od_tuners->up_threshold) {
 		/* If switching to max speed, apply sampling_down_factor */
 		if (policy->cur < policy->max)
 			dbs_info->rate_mult =
 				od_tuners->sampling_down_factor;
 		dbs_freq_increase(policy, policy->max);
 		return;
-	}
-
-	/* Check for frequency decrease */
-	/* if we cannot reduce the frequency anymore, break out early */
-	if (policy->cur == policy->min)
-		return;
-
-	/*
-	 * The optimal frequency is the frequency that is the lowest that can
-	 * support the current CPU usage without triggering the up policy. To be
-	 * safe, we focus 10 points under the threshold.
-	 */
-	if (load_freq < od_tuners->adj_up_threshold
-			* policy->cur) {
+	} else {
+		/* Calculate the next frequency proportional to load */
 		unsigned int freq_next;
-		freq_next = load_freq / od_tuners->adj_up_threshold;
+		freq_next = load * policy->cpuinfo.max_freq / 100;
 
 		/* No longer fully busy, reset rate_mult */
 		dbs_info->rate_mult = 1;
@@ -372,9 +354,6 @@ static ssize_t store_up_threshold(struct dbs_data *dbs_data, const char *buf,
 			input < MIN_FREQUENCY_UP_THRESHOLD) {
 		return -EINVAL;
 	}
-	/* Calculate the new adj_up_threshold */
-	od_tuners->adj_up_threshold += input;
-	od_tuners->adj_up_threshold -= od_tuners->up_threshold;
 
 	od_tuners->up_threshold = input;
 	return count;
@@ -523,8 +502,6 @@ static int od_init(struct dbs_data *dbs_data)
 	if (idle_time != -1ULL) {
 		/* Idle micro accounting is supported. Use finer thresholds */
 		tuners->up_threshold = MICRO_FREQUENCY_UP_THRESHOLD;
-		tuners->adj_up_threshold = MICRO_FREQUENCY_UP_THRESHOLD -
-			MICRO_FREQUENCY_DOWN_DIFFERENTIAL;
 		/*
 		 * In nohz/micro accounting case we set the minimum frequency
 		 * not depending on HZ, but fixed (very low). The deferred
@@ -533,8 +510,6 @@ static int od_init(struct dbs_data *dbs_data)
 		dbs_data->min_sampling_rate = MICRO_FREQUENCY_MIN_SAMPLE_RATE;
 	} else {
 		tuners->up_threshold = DEF_FREQUENCY_UP_THRESHOLD;
-		tuners->adj_up_threshold = DEF_FREQUENCY_UP_THRESHOLD -
-			DEF_FREQUENCY_DOWN_DIFFERENTIAL;
 
 		/* For correct statistics, we need 10 ticks for each measure */
 		dbs_data->min_sampling_rate = MIN_SAMPLING_RATE_RATIO *
-- 
1.8.1.4

--
To unsubscribe from this list: send the line "unsubscribe cpufreq" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Kernel Devel]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite Forum]     [Linux SCSI]

  Powered by Linux