The driver is based on clock and regulator APIs and support single core and multi core ARM SoCs. For multi core, it assume all cores share the same clock and voltage. Thanks Arnd, Mark, Jamie, Shawn, Rob, for your review. Changes in V6: - add scaling_available_freqs Changes in V5: - add more comments - rename trans-latency to clk-trans-latency, and it only describe clk latency. Regulator latency is got from regulator_set_voltage_time. Changes in v4: - add depends on HAVE_CLK && OF && REGULATOR - add set_cpu_freq fail check - regulator_put wehn module exit - add pr_fmt and convert all printk to pr_xxx - use voltage range - comment and doc fix - add cpu_volts value pre-check in module init - add helpfull module parameter max_freq - remove compatible string check on Arnd's comment. - remove generic-cpufreq to clk-reg-cpufreq Changes in v3: - move adjusting smp loops_per_jiffy to arm common code, and also adjust global loops_per_jiffy. - remove adjusting loops_per_jiffy in imx and omap cpufreq drivers. - check compatible "generic-cpufreq" when module_init - change printk to pr_xxx - add generic-cpufreq DT binding doc Changes in v2: - add volatage change support - change '_' in property name to '-' - use initial value to calculate loops_per_jiffy - fix reading cpu_volts property bug - let cpufreq_frequency_table_cpuinfo routines handle cpu_freq_khz_max/min - don't change freq in arm_cpufreq_exit, because every core share the same freq. - use unsigned long describe frequency as much as possible. Because clk use unsigned long, but cpufreq use unsigned int. [PATCH V6 1/7] ARM: add cpufreq transiton notifier to adjust [PATCH V6 2/7] arm/imx: cpufreq: remove loops_per_jiffy recalculate [PATCH V6 3/7] cpufreq: OMAP: remove loops_per_jiffy recalculate for [PATCH V6 4/7] cpufreq: add clk-reg cpufreq driver [PATCH V6 5/7] dts/imx6q: add cpufreq property [PATCH V6 6/7] arm/imx6q: register arm_clk as cpu to clkdev [PATCH V6 7/7] arm/imx6q: select ARCH_HAS_CPUFREQ Thanks Richard -- To unsubscribe from this list: send the line "unsubscribe cpufreq" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
