On Monday 02 March 2009 19:23:09 Sitsofe Wheeler wrote: > On Mon, Mar 02, 2009 at 06:33:46PM +0200, Denys Fedoryschenko wrote: > > CPUFreq infrastructure much more powerful. > > -d --min <FREQ> > > new minimum CPU frequency the governor may select. > > -u --max <FREQ> > > new maximum CPU frequency the governor may select. > > -g --governor <GOV> > > new cpufreq governor. > > > > This things you cannot do over inserting values over ACPI. Sure you can > > reinvent the wheel, but why? > > I guess I don't understand why you would want scaling if it didn't save > you any power... If i will limit current in certain limits, rather than using high current, i will have in result higher efficiency of discharging battery. The discharge curves for a Lithium Ion cell below show that the effective capacity of the cell is reduced if the cell is discharged at very high rates (or conversely increased with low discharge rates). This is called the capacity offset and the effect is common to most cell chemistries. If the discharge takes place over a long period of several hours as with some high rate applications such as electric vehicles, the effective capacity of the battery can be as much as double the specified capacity at the C rate. This can be most important when dimensioning an expensive battery for high power use. The capacity of low power, consumer electronics batteries is normally specified for discharge at the C rate whereas the SAE uses the discharge over a period of 20 hours (0.05C) as the standard condition for measuring the Amphour capacity of automotive batteries. The graph below shows that the effective capacity of a deep discharge lead acid battery is almost doubled as the discharge rate is reduced from 1.0C to 0.05C. For discharge times less than one hour (High C rates) the effective capacity falls off dramatically. This means even i need to recode on battery movie (clearly need same amount of processing power), if i do it with 100% CPU available let's say in 30 minutes, and if i do it with 50% CPU available in 60 minutes, at the end i should have DIFFERENT amount of remaining battery. Another example, if i run screensaver i want governor powersave(so some crazy flash plugin don't dry out battery till i come back) , if i run on battery i will put conservative and limit frequency range to max 50% of CPU power, so i can be sure my laptop lasts enough time. This in case battery time matter for me more than computing power. Sure i will prefer some universal way, so i can set same rules on Core 2 Duo based laptop, and cheap Celeron. Cpufreq provide me useful framework for this job, and important SAME API everywhere. Less efficient on p4-clockmod, and very efficient on true "mobile" processors. * Many things quoted from http://www.mpoweruk.com/performance.htm -- To unsubscribe from this list: send the line "unsubscribe cpufreq" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
