Re: Tripp Lite PDU

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Marek,

This is the agent I wrote. I have not done a man page or perldoc for it, but it is documented in the comments.

Regards,
Erik Dorthé
NOC Engineer
CARI.net
858.974.5080 x217
edorthe@xxxxxxxx



On Mon, Feb 11, 2013 at 10:23 AM, Marek Grac <mgrac@xxxxxxxxxx> wrote:
On 02/11/2013 05:36 PM, Erik Dorthe wrote:
I know there has been an agent submitted for this before (see link at the bottom of this email), but I created an agent for the Tripp Lite SNMP Management Card. This agent uses SNMP to issue commands to a Tripp Lite PDU. I have found that some of the limitations mentioned in the past do not seem to exist anymore, which may be a result of a firmware update (I am using version 12.06.0061).

The primary limitation was a delay in the power state change, which had taken up to 35 seconds in the past. I have found no delay over 10 seconds, which improves response time significantly.

I have put this agent into testing in a prototype cluster, and my initial results look good. The model I am testing with is a PDUMH20ATNET. If anyone would like to look over the agent or review it for inclusion, please contact me.
Sure, please resend agent to me

m,

--
Linux-cluster mailing list
Linux-cluster@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/linux-cluster

Attachment: fence_tripplite_snmp
Description: Binary data

-- 
Linux-cluster mailing list
Linux-cluster@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/linux-cluster

[Index of Archives]     [Corosync Cluster Engine]     [GFS]     [Linux Virtualization]     [Centos Virtualization]     [Centos]     [Linux RAID]     [Fedora Users]     [Fedora SELinux]     [Big List of Linux Books]     [Yosemite Camping]

  Powered by Linux