On Mon, Jun 6, 2011 at 2:53 PM, Manish Kathuria <mkathuria@xxxxxxxxxxxxxxxxxxxxx> wrote:
I am facing a strange problem configuring a two node cluster using
RHCS 4.8. Both nodes are HP Proliant DL 180 G6 servers using HP LO
100i (IPMI Based).
When I run the fence_node command to check the fence device
configuration for either of the nodes, it fails giving the following
message in the logs:
fence_node[nnnn]: Fence of "node1" was unsuccessful
fence_node[nnnn]: Fence of "node2" was unsuccessful
However, when I run the fence_impilan command using the same
credentials, it executes successfully and is able to switch on, off
and reboot the nodes. The cluster configuration for the fence devices
is:
IPMI Lan Type
Name: lo1
IP Address: 172.16.1.x
Login admin
Password passone
Auth Type password
Name: lo2
IP Address: 172.16.1.y
Login admin
Password passtwo
Auth Type password
I have already tried different options for Auth Type (blank, password,
md5). Have also tried using / not using lanplus for both the fence
devices in the Manage Fencing dialog without success.
Any suggestions ?
Thanks,
Manish Kathuria
--
Linux-cluster mailing list
Linux-cluster@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/linux-cluster
-- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster
