Sorry if this reply is a repeat. I sent a reply to this post when my mail client was foolishly not set for plaintext emails only. As far as I can tell the list manager has stripped it, but it could just be slow. Apologies again if that's the case. --------------------------------------------------------- Hi, Your issue is likely not to be cluster related, but a problem with routing or name resolution. Please send the outputs of the following commands to me privately (not replied to the list) so I can assist: cat /etc/nsswitch.conf netstat -rn ip rule show ip route show cat /etc/hosts cat /etc/resolv.conf nslookup 172.38.1.17 nslookup 172.38.1.18 nslookup 192.168.190.86 nslookup 192.168.190.87 nslookup ricci1b.gallup.com nslookup ricci2b.gallup.com nslookup ricci1b-ic.gallup.com nslookup ricci2b-ic.gallup.com ifconfig -a Any configs that relate to how eth1 and eth2 are bonded. Also, not that I think it makes a difference, but 172.38.0.0 is *not* a part of the IANA reserved address space for private use (if that's what you were intending). For further info, please read section 3 of RFC 1918 at http://www.isi.edu/in-notes/rfc1918.txt. I doubt this would relate to your problem, however. Regards, Stewart ----------------------------------------------------- Alternate NIC for clustering * From: "Hunt, Gary" <Gary_Hunt gallup com> * To: "Linux-cluster redhat com" <Linux-cluster redhat com> * Cc: * Subject: Alternate NIC for clustering * Date: Thu, 12 Feb 2009 13:26:17 -0600 Does anyone know how to get the cluster to use an alternate private network for clustering? I have 2 nodes RHEL 5.3 Eth0 is the public interface Eth1 and eth2 are bonded I added entries for the bonded interface in both hosts file. Here is my hosts file 192.168.190.86 ricci1b ricci1b.gallup.com 192.168.190.87 ricci2b ricci2b.gallup.com 172.38.1.17 ricci1b-ic ricci1b-ic.gallup.com 172.38.1.18 ricci2b-ic ricci2b-ic.gallup.com Here is my cluster.conf <?xml version="1.0"?> <cluster alias="xencluster" config_version="1" name="xencluster"> <fence_daemon post_fail_delay="0" post_join_delay="3"/> <clusternodes> <clusternode name="ricci2b-ic.gallup.com" nodeid="1" votes="1"/> <clusternode name="ricci1b-ic.gallup.com" nodeid="2" votes="1"/> </clusternodes> <cman expected_votes="1" two_node="1"/> <fencedevices/> <rm/> </cluster> I get this error in my log file Feb 12 11:34:27 ricci1b openais[6353]: [MAIN ] local node name "ricci1b.gallup.com" not found in cluster.conf Thanks Gary -- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster
