Hi Harri, Please consider using a smart mailclient which can wrap your mails.. It makes things a lot easier. I have a 2 node cluster RHEL5.1 on 64bit (IBM Blades) configured which works well for me (so far). Harri.Paivaniemi@xxxxxxxxxxxxxxx wrote: > 1. 2-node cluster. Can't start only one node to get cluster services >up - it hangs in fencing and waits until I start te second node and >immediately after that, when both nodes are starting cman, the cluster >comes up. For me fencing would hang for 3-4 minutes before I had properly configured fencing (with manual fallback), after adding manual fallback I no longer have this issue. When a node is fenced / rebooted, every now and then it will fence the other node on restart. And if I shutdown and restart both nodes simultaneously they will fence like this (has happened 2 times on tests) A boots quicker and establishes the cluster B fences A when it starts A fences B when it starts B boots and joins the cluster.. This was before I configured qdisk, and I have not yet tested this behaviour after qdisk was setup. > 2. qdisk doesn't work. 2- node cluster. Start it (both nodes at the qdisk works well for me in a very similar setup. I have done manual fencing tests / hardboot tests, which didn't produce anything like you describe. > 3. Funny thing: heuristic ping didn't work at all in the beginning >and support gave me a "ping-script" which make it to work... so this >describes quite well how experimental this cluster is nowadays... heuristic ping works fine for me out of the box.. Regards -- Denis -- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster