Does anyone know a good resource/howto on primary/primary setup? Thanks rob -----Original Message----- From: linux-cluster-bounces@xxxxxxxxxx [mailto:linux-cluster-bounces@xxxxxxxxxx] On Behalf Of Igor Zhbanov Sent: 11 December 2006 21:10 To: linux-cluster@xxxxxxxxxx Subject: Building SAN with Red Hat Cluster. Is it possible? Hello! I want to build system consisting of several frontend-nodes and two-four backend (storage) nodes. I don't want to use hardware shared storage for some reasons. So, we can use some networking block device to connect two nodes (e.g. DRBD v0.8 in primary/primary mode, or GNBD?) if needed. The question, is it possible to setup Red Hat Cluster in such configuration: 1) over DRBD or local hard drives if possible on two or four storage nodes; 2) to be able mount file system at frontend nodes which have no direct access to shared storage device, i.g. is it possible to mount file system over network?; 3) to have failover and load-balancing storage nodes, so each node will hold entire copy of stored data, so storage nodes can be accessed in parallel and if one node goes down, system will function correctly. 4) If it is possible to mount file system on some other node, will it be mounted as file system or firstly some block device will be exported to that node and file system will be mounted over it? Thank you. -- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster -- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster
