Hi All, Have been testing rhcs on a FC5 box or two for a while for eventual creation of a small cluster (3 nodes) for a small area of our project. In the tests it worked fine. However, naturally enough, now that I come to install properly on new bought-for-the-task hardware, its not working as thought... Everything compiles fine and looks pretty good. All the ko's load fine and apps are installed as expected. However when I startup ccsd it fails, with... ### Failed to connect to cluster manager Hint: Magma plugins are not in the right spot ### I have googled, and looked on the FAQ, where the suggested answer (I compiled from the stable 1.03.00 tarball) was to run a make uninstall, make distclean and then re-compile. I have done this, however it still doesn't seem to work, I get the same failure. If I run # magma_tool list it says things are OK, and displays the (it says OK) magma plugins. It also says it is looking at /usr/lib/magma for them, which I presume is the default.li
Not sure if this is the problem, but 64bit machines are looking for libraries in /usr/lib64. When you do the configure, set --libdir=/usr/lib64 and rebuild, this might fix the problem you are seeing. since You are on an x86_64 box.
The only difference between this and the previous machines I was testing on, is that these are x86_64 boxes, rather than i386 and as such I am using the x86_64 distro. Kernel and cluster versions are the same, and so far it's a vanilla install apart from adding gcc, etc to compile the cluster stuff. I'm guessing that its some kind of confusion with the 64-bit stuff. Is there any special configure arguments I am supposed to add when compiling, I couldn't find any in the docs or in configure itself. Any ideas??? TIA Dan -- Dan Hawker Linux System Administrator Astrium
-- Linux-cluster mailing list Linux-cluster@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/linux-cluster
