On Mon, 2005-08-29 at 02:26 +0000, nattapon viroonsri wrote: > I use RedHat cluster v4 for HA and have no power switch hardware > When i disconnected network cable for client access resource , Failover > have occur as expect > But the server that was disconnect network cable not be rebooted or fenced > like rhcs V3(even no power switch). And the failed server can't not join > cluster again. Eep, no failover should have occurred if you don't have fencing. > In Rhcs V3. it reboot fail node automatically without hardware power switch > > So, Have anyway to reboot failed node(network problem or server problem) > without use hardware power switch to make failnode to clean state again ? You need fencing hardware with RHCS4/RHEL4. I'd check ebay if you're not looking to spend a lot, you can get a WTI NPS115 for pretty cheap nowadays (under $100!). You can run with manual fencing, but no automatic recovery will occur, and this isn't a supported solution. -- Lon -- Linux-cluster@xxxxxxxxxx http://www.redhat.com/mailman/listinfo/linux-cluster
