Re: [PATCH 2/5] cgroup/cpuset: Add new cpus.partition type with no load balancing

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jun 03, 2021 at 05:24:13PM -0400, Waiman Long wrote:
> Cpuset v1 uses the sched_load_balance control file to determine if load
> balancing should be enabled.  Cpuset v2 gets rid of sched_load_balance
> as its use may require disabling load balancing at cgroup root.
> 
> For workloads that require very low latency like DPDK, the latency
> jitters caused by periodic load balancing may exceed the desired
> latency limit.
> 
> When cpuset v2 is in use, the only way to avoid this latency cost is to
> use the "isolcpus=" kernel boot option to isolate a set of CPUs. After
> the kernel boot, however, there is no way to add or remove CPUs from
> this isolated set. For workloads that are more dynamic in nature, that
> means users have to provision enough CPUs for the worst case situation
> resulting in excess idle CPUs.
> 
> To address this issue for cpuset v2, a new cpuset.cpus.partition type
> "root-nolb" is added which allows the creation of a cpuset partition with
> no load balancing. This will allow system administrators to dynamically
> adjust the size of the no load balancing partition to the current need
> of the workload without rebooting the system.

I'm confused, why do you need this? Just create a parition for each cpu.



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]     [Monitors]

  Powered by Linux