> So you suggest to give this command: > > ceph config set global mon_target_pg_per_osd 200 > > right? If I understood the meaning of this parameter then it is meaningful when automated PG scaling is on, but it is currently off for the data partition: > > # ceph osd pool get wizard_data pg_autoscale_mode > pg_autoscale_mode: off > > So should I proceed anyway? Sorry to bother you but I'm not sure I understood your suggestion and I fear I could make a mistake at this point. Yes. Had you turned off autoscaling for that pool so you could set it manually? I might suggest enabling or disabling for all pools, vs having a mix. If the data pool doesn’t get enough PGs with the autoscaler on, I might increase its BIAS value. > _______________________________________________ > ceph-users mailing list -- ceph-users@xxxxxxx > To unsubscribe send an email to ceph-users-leave@xxxxxxx _______________________________________________ ceph-users mailing list -- ceph-users@xxxxxxx To unsubscribe send an email to ceph-users-leave@xxxxxxx
 |