Good morning everyone, been running a small Ceph cluster with Proxmox for a while now and I’ve finally run across an issue I can’t find any information on. I have a 3 node cluster with 9 Samsung PM983 960GB NVME drives running on a dedicated 10gb network. RBD and CephFS performance have been great, most of the time I see over 500MBs writes and a rados benchmark shows 951 MB/s write and 1140 MB/s read bandwidth. The problem I’m seeing is after setting up RadosGW I can only upload to “S3” at around 25MBs with the official AWS CLI. Using s3cmd is slightly better at around 45MB/s. I’m going directly to the RadosGW instance with no load balancers in between and no ssl enabled. Just trying to figure out if this is normal. I’m not expecting it to be as fast as writing directly to a RBD but I was kinda hoping for more than this. So what should I expect in performance from the RadosGW? Here are some rados bench results and my ceph report https://gist.github.com/shawnweeks/f6ef028284b5cdb10d80b8dc0654eec5 https://gist.github.com/shawnweeks/7cfe94c08adbc24f2a3d8077688df438 Thanks Shawn _______________________________________________ ceph-users mailing list -- ceph-users@xxxxxxx To unsubscribe send an email to ceph-users-leave@xxxxxxx
 |