Re: MTU mismatch error in Ceph dashboard

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Yes - you’re right. It’s complaining about eno1 and eno2 which I’m not using. I’ll change those and it will probably make the error go away. I’m guessing something changed between 16.2.4 and 16.2.5 because I didn’t start seeing this error until after the upgrade. 

-Paul


> On Aug 4, 2021, at 5:09 PM, Kai Stian Olstad <ceph+list@xxxxxxxxxx> wrote:
> 
> On 04.08.2021 22:06, Paul Giralt (pgiralt) wrote:
>> I did notice that docker0 has an MTU of 1500 as do the eno1 and eno2
>> interfaces which I’m not using. I’m not sure if that’s related to the
>> error. I’ve been meaning to try changing the MTU on the eno interfaces
>> just to see if that makes a difference but haven’t gotten around to
>> it.
> 
> If you look at the message it says which interface it is.
> 
> It does check and report on all the interfaces, even those that is in DOWN state which it shouldn't.
> 
> 
> -- 
> Kai Stian Olstad

_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx




[Index of Archives]     [Information on CEPH]     [Linux Filesystem Development]     [Ceph Development]     [Ceph Large]     [Ceph Dev]     [Linux USB Development]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [xfs]


  Powered by Linux