The way I did is I create a new pool, copy data on it and put the new pool in place of the old one after I delete the former pool echo "--------------------------------------------------------------------" echo " Create a new pool with erasure coding" echo "--------------------------------------------------------------------" sudo ceph osd pool create $pool.new 64 64 erasure ecprofile-5-3 echo "--------------------------------------------------------------------" echo " Copy the original pool to the new pool" echo "--------------------------------------------------------------------" sudo rados cppool $pool $pool.new echo "--------------------------------------------------------------------" echo " Rename the original pool to .old" echo "--------------------------------------------------------------------" sudo ceph osd pool rename $pool $pool.old echo "--------------------------------------------------------------------" echo " Rename the new erasure coding pool to $pool" echo "--------------------------------------------------------------------" sudo ceph osd pool rename $pool.new $pool echo "--------------------------------------------------------------------" echo " Set the pool: $pool to autoscaling" echo "--------------------------------------------------------------------" sudo ceph osd pool set $pool pg_autoscale_mode on echo "--------------------------------------------------------------------" echo " Show detail off the new create pool" echo "--------------------------------------------------------------------" sudo ceph osd pool get $pool all Sylvain -----Message d'origine----- De : Michael Fladischer <michael@xxxxxxxx> Envoyé : 22 juin 2020 15:23 À : ceph-users@xxxxxxx Objet : Re: OSD crash with assertion Turns out, I really messed up when changing the EC profile. Removing the pool did not get rid of it's PGs on the OSDs that have crashed. To get my OSDs back up I used ceph-objectstore-tool like this: for PG in $(ceph-objectstore-tool --data-path $DIR --type=bluestore --op=list-pgs |grep '^$POOL_ID'); do ceph-objectstore-tool --data-path $DIR --type=bluestore --op=remove --force --pgid=$PG done $DIR is the data path of the crashed OSD. $POOL_ID is the ID of the pool with the messed up EC profile. I'm now curious if there is an easier way to do this? After getting rid of all PGs the OSD were able to start again. Hope this helps someone. Regards, Michael Am 22.06.2020 um 19:46 schrieb Michael Fladischer: > Hi, > > a lot of our OSD have crashed a few hours ago because of a failed > assertion: > > /build/ceph-15.2.3/src/osd/ECUtil.h: 34: FAILED > ceph_assert(stripe_width % stripe_size == 0) > > Full output here: > https://pastebin.com/D1SXzKsK > > All OSDs are on bluestore and run 15.2.3. > > I think I messed up when I tried to change an existing EC profile > (using > --force) for an active EC pool. > > I already tried to delete the pool and the EC profile and start the > OSDs but they keep crashing with the same assertion. > > Is there a way to at least find out what the values are for > stripe_width and stripe_size? > > Regards, > Michael > _______________________________________________ > ceph-users mailing list -- ceph-users@xxxxxxx To unsubscribe send an > email to ceph-users-leave@xxxxxxx _______________________________________________ ceph-users mailing list -- ceph-users@xxxxxxx To unsubscribe send an email to ceph-users-leave@xxxxxxx _______________________________________________ ceph-users mailing list -- ceph-users@xxxxxxx To unsubscribe send an email to ceph-users-leave@xxxxxxx
 |