So this OSD has 32M of shared blobs and fsck loads them all into memory
while processing. Hence the RAM consumption.
I'm afraid there is no simple way to fix that, will create a ticket though.
And a side question:
1) Do you use erasure coding and/or compression for rbd pool?
These stats look suspicious
POOL ID STORED (DATA) (OMAP) OBJECTS
USED (DATA) (OMAP) %USED MAX AVAIL QUOTA OBJECTS QUOTA BYTES
DIRTY USED COMPR UNDER COMPR
rbd 1 245 TiB 245 TiB 9.0 MiB 50.26M 151
TiB 151 TiB 9.0 MiB 90.03 12 TiB N/A N/A 50.26M
35 TiB 144 TiB
Stored - 245 TiB, Used - 151 TiB
Can't imagine any explanation other than applied compression.
Thanks,
Igor
On 4/2/2020 5:59 PM, Jack wrote:
Here it is
On 4/2/20 3:48 PM, Igor Fedotov wrote:
And may I have the output for:
ceph daemon osd.N calc_objectstore_db_histogram
This will collect some stats on record types in OSD's DB.
On 4/2/2020 4:13 PM, Jack wrote:
(fsck / quick-fix, same story)
On 4/2/20 3:12 PM, Jack wrote:
Hi,
A simple fsck eats the same amount of memory
Cluster usage: rbd with a bit of rgw
Here is the ceph df detail
All OSDs are single rusty devices
On 4/2/20 2:19 PM, Igor Fedotov wrote:
Hi Jack,
could you please try the following - stop one of already converted OSDs
and do a quick-fix/fsck/repair against it using ceph_bluestore_tool:
ceph-bluestore-tool --path <path to osd> --command
quick-fix|fsck|repair
Does it cause similar memory usage?
You can stop experimenting if quick-fix reproduces the issue.
Also could you please describe your cluster and its usage a bit: what's
the usage: rgw/rbd/cephfs? If possible - please share 'ceph df detail'
output, do you have standalone DB volume at SSD/NVMe?
Thanks,
Igor
On 4/1/2020 6:28 PM, Jack wrote:
Hi,
As the upgrade documentation tells:
Note that the first time each OSD starts, it will do a format
conversion to improve the accounting for “omap” data. This may
take a few minutes to as much as a few hours (for an HDD with lots
of omap data). You can disable this automatic conversion with:
What the documentation does not say is that this process takes a
lot of
memory
I am upgrading a rusty cluster from Nautilus, you can check out the
ram
consumption as attachment
First, we have a 3TB osd conversion: it tooks ~15min, and 19GB of
memory
Then, we have a larger 6TB osd conversion: it tooks more than 2 hours,
and 35GB of memory
Finally, you have the largest 10TB osd: only 1H15, but 52GB of memory
_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx
_______________________________________________
ceph-users mailing list -- ceph-users@xxxxxxx
To unsubscribe send an email to ceph-users-leave@xxxxxxx
