Signed-off-by: Venky Shankar <vshankar@xxxxxxxxxx> --- Documentation/filesystems/ceph.rst | 25 ++++++++++++++++++++++--- 1 file changed, 22 insertions(+), 3 deletions(-) diff --git a/Documentation/filesystems/ceph.rst b/Documentation/filesystems/ceph.rst index 7d2ef4e27273..4942e018db85 100644 --- a/Documentation/filesystems/ceph.rst +++ b/Documentation/filesystems/ceph.rst @@ -82,7 +82,7 @@ Mount Syntax The basic mount syntax is:: - # mount -t ceph monip[:port][,monip2[:port]...]:/[subdir] mnt + # mount -t ceph user@fsid.fs_name=/[subdir] mnt -o mon_addr=monip1[:port][/monip2[:port]] You only need to specify a single monitor, as the client will get the full list when it connects. (However, if the monitor you specify @@ -90,16 +90,35 @@ happens to be down, the mount won't succeed.) The port can be left off if the monitor is using the default. So if the monitor is at 1.2.3.4:: - # mount -t ceph 1.2.3.4:/ /mnt/ceph + # mount -t ceph cephuser@07fe3187-00d9-42a3-814b-72a4d5e7d5be.cephfs=/ /mnt/ceph -o mon_addr=1.2.3.4 is sufficient. If /sbin/mount.ceph is installed, a hostname can be -used instead of an IP address. +used instead of an IP address and the cluster FSID can be left out +(as the mount helper will fill it in by reading the ceph configuration +file):: + # mount -t ceph cephuser@cephfs=/ /mnt/ceph -o mon_addr=mon-addr +Multiple monitor addresses can be passed by separating each address with a slash (`/`):: + + # mount -t ceph cephuser@cephfs=/ /mnt/ceph -o mon_addr=192.168.1.100/192.168.1.101 + +When using the mount helper, monitor address can be read from ceph +configuration file if available. Note that, the cluster FSID (passed as part +of the device string) is validated by checking it with the FSID reported by +the monitor. Mount Options ============= + mon_addr=ip_address[:port][/ip_address[:port]] + Monitor address to the cluster. This is used to bootstrap the + connection to the cluster. Once connection is established, the + monitor addresses in the monitor map are followed. + + fsid=cluster-id + FSID of the cluster (from `ceph fsid` command). + ip=A.B.C.D[:N] Specify the IP and/or port the client should bind to locally. There is normally not much reason to do this. If the IP is not -- 2.27.0
