On Wed, Jul 8, 2015 at 5:17 PM, Deneau, Tom <tom.deneau@xxxxxxx> wrote: > With the newer rados, just running rados -p somepool load-gen, we get > > preparing 200 objects > load-gen will run 60 seconds > 1: throughput=0MB/sec pending data=0 > 2: throughput=0MB/sec pending data=0 > 3: throughput=0MB/sec pending data=0 > 4: throughput=0MB/sec pending data=0 > 5: throughput=0MB/sec pending data=0 > 6: throughput=0MB/sec pending data=0 > > But I see the change that caused this behavior was explicitly initializing lg.max_ops to 0. > Before this, max_ops was just whatever happened to be in memory. > > So the newer load-gen works fine as long as you explicitly set --max-ops on the command line. Can you create a ticket on the tracker describing this issue? That's the kind of thing we'll want to fix. ;) -Greg > > -- Tom Deneau > > >> -----Original Message----- >> From: Gregory Farnum [mailto:greg@xxxxxxxxxxx] >> Sent: Wednesday, July 01, 2015 11:05 AM >> To: Deneau, Tom >> Cc: ceph-devel >> Subject: Re: load-gen from an osd node >> >> Hmm, the only changes I see between those two versions are some pretty >> precise cleanups which shouldn't cause this. But it means that a bisect or >> determined look should be easy. Can you create a ticket which includes the >> exact output you're seeing and the exact versions you're running? >> -Greg >> >> On Mon, Jun 29, 2015 at 11:27 PM, Deneau, Tom <tom.deneau@xxxxxxx> wrote: >> > Oh, I just noticed that the client nodes I spoke of where load-gen >> > actually worked were running 0.94, not 9.0.1. And when I upgrade them to >> 9.0.1, load-gen no longer works. >> > >> > So more likely this is just a problem with newer rados load-gens >> > >> > -- Tom >> > >> > >> > >> >> -----Original Message----- >> >> From: Deneau, Tom >> >> Sent: Friday, June 26, 2015 7:48 PM >> >> To: ceph-devel >> >> Subject: load-gen from an osd node >> >> >> >> I am running 9.0.1 and I noticed when I run rados load-gen from one >> >> of the osd nodes, it creates the objects but then always reports a >> >> throughput of 0 MB/sec. >> >> >> >> But if I run it from a separate client node, it works fine. >> >> Why would this be? >> >> >> >> I'm not sure but I thought in earlier versions load-gen could be run >> >> from an osd node. >> >> >> >> -- Tom Deneau >> > -- >> > To unsubscribe from this list: send the line "unsubscribe ceph-devel" >> > in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo >> > info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe ceph-devel" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
