Getting "bnx2i: iSCSI not supported, dev=eth0" for all the NIC adapters
on all of my R710's running CentOS 5.5.
Here is an sample of the error messages:
bonding: Warning: either miimon or arp_interval and arp_ip_target module
parameters must be specified, otherwise bonding will not detect link
failures! see bonding.txt for details.
bonding: bond0: setting mode to active-backup (1).
bonding: bond0: Setting MII monitoring interval to 500.
ADDRCONF(NETDEV_UP): bond0: link is not ready
bonding: bond0: Adding slave eth0.
bnx2: eth0: using MSIX
bnx2i: iSCSI not supported, dev=eth0
bonding: bond0: enslaving eth0 as a backup interface with a down link.
bnx2i: iSCSI not supported, dev=eth0
bonding: bond0: Adding slave eth2.
bnx2: eth2: using MSIX
bnx2i: iSCSI not supported, dev=eth2
bnx2: eth0 NIC Copper Link is Up, 1000 Mbps full duplex
bonding: bond0: enslaving eth2 as a backup interface with a down link.
bnx2i: iSCSI not supported, dev=eth2
bonding: bond0: link status definitely up for interface eth0.
bonding: bond0: making interface eth0 the new active one.
bonding: bond0: first active interface up!
bonding: bond0: link status definitely up for interface eth2.
ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready
bonding: bond0: link status definitely down for interface eth2, disabling it
bnx2: eth2 NIC Copper Link is Up, 1000 Mbps full duplex
bonding: bond0: link status definitely up for interface eth2.
bond0: no IPv6 routers present
Understanding that bnx2i is used for hardware iscsi, why is this error
occurring?
David
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
