On 2.7.2010 04:46, Scott Beardsley wrote:
>>>> From start to finish anaconda needs to pick up a dynamic address
>>>> from vlan 100. After that the kickstart file specifies the static
>>>> adress from vlan100 and it's address from the backup subnet.
>>>> Anyone know if this is currently possible? If so any nod in the
>>>> right direction would be appreciated
>> I dunno how you'd get the BIOS to do a PXE boot off a vlan.
> I remember running into this a while ago. I think most multi-layer
> switches can have a default VLAN that untagged packets will go to. Check
> the docs for your switch.
>
> Scott
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
On Cisco switches it would be called "native vlan" if i remember correctly:
One way of doing it (if using Cisco :):
interface GigabitEthernet0/1
description nodeX
switchport trunk native vlan 100
switchport trunk allowed vlan 100,101
switchport mode trunk
spanning-tree portfast trunk
spanning-tree bpdufilter enable
end
Bgrds,
Finnur
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
