On May 15, 2010, at 7:13 AM, Dominik Zyla <gavroche@xxxxxxxxxxx> wrote:
> On Fri, May 14, 2010 at 03:02:04PM -0400, Jerry Geis wrote:
>>>
>>> GATEWAY=74.223.8.177 on /etc/sysconfig/network file ?
>>>
>> Actually I have that in the ifcfg-eth1 and ifcfg-eth2. And this is
>> hte
>> route I get.
>>
>> DEVICE=eth1
>> ONBOOT=YES
>> BOOTPROTO=static
>> IPADDR=74.223.8.179
>> NETMASK=255.255.255.240
>> GATEWAY=74.223.8.177
>>
>>
>> DEVICE=eth2
>> ONBOOT=Yes
>> BOOTPROTO=static
>> IPADDR=24.123.23.170
>> NETMASK=255.255.255.248
>> GATEWAY=24.123.23.169
>>
>> route -n
>> Kernel IP routing table
>> Destination Gateway Genmask Flags Metric Ref
>> Use
>> Iface
>> 24.123.23.168 0.0.0.0 255.255.255.248 U 0
>> 0 0 eth2
>> 74.223.8.176 0.0.0.0 255.255.255.240 U 0
>> 0 0 eth1
>> 192.168.1.0 0.0.0.0 255.255.255.0 U 0
>> 0 0 eth0
>> 169.254.0.0 0.0.0.0 255.255.0.0 U 0
>> 0 0 eth2
>> 0.0.0.0 24.123.23.169 0.0.0.0 UG 0
>> 0 0 eth2
>>
>>
>> I dont want 74.X traffic going out 24.X network. I want it going back
>> out the 74.X network.
>> How do I setup the ifcfg-eth files so the GW above will route back
>> out
>> the correct gw?
>
> It won't work. You can't have two default gateways. Init scripts first
> set your gateway via eth1, then parse ifcfg-eth2 (alphabetical) and
> overwrites previous settings.
True, you can have only one gateway of last resort and the OP needs to
pick which one, but you can do policy based routing in iptables, and
if reverse NAT is configured I believe incoming connections should
work as advertised.
There was a thread just recently discussing solutions for this type of
setup.
-Ross
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
