On Oct 5, 2009, at 8:34 PM, Benjamin Franz wrote:
> Robert Heller wrote:
>>
>> Right. You'll *have* to get at least a socket-7 motherboard with a
>> K6
>> processor and DIMM RAM sockets and PCI bus, if only because getting
>> old-school SIMMs is hard these days. And getting a distro with
>> install
>> kernels (much less stock kernels) for less than a 586 is getting
>> hard,
>> unless you opt for something like Slackware or Linux From Scratch.
>> In
>> practice any still working minimually i686 system with a reasonable
>> amount of RAM (for just a DNS server, 256meg RAM and a 20-40 GIG IDE
>> disk, would probably even be enough to install, say, CentOS). I
>> recently installed CentOS 5.2 on a old Dell box (PII or PIII vintage)
>> with an 18gig disk. No X11. Just DNS, DHCPD, PPPD, Samba, CUPS, and
>> little else. This little box is just being used as a dialup
>> 'router'.
>> It is jacked into a wireless 'router', but the wireless router is
>> just
>> being used as an accesspoint and Ethernet switch (this is a home
>> setup
>> -- broadband is not presently available, only dialup internet).
>>
>>
>>
>>
>
> I replaced a modern retail firewall/router with a 500 Mhz Celeron with
> 512K RAM (Intel 810e motherboard) and a PCI dual port ethernet card
> of
> because the 'modern' POS turnkey couldn't handle 100 mbits/second
> through the WAN interface. The 500Mhz celeron with CentOS5 handled
> that
> plus DNS and DHCP without ever cracking 1% CPU usage.
That proves 614K should be enough for anybody.
Giovanni P. Tirloni
tirloni@xxxxxxxxx
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
