Hi,
did you try:
iptables -I FORWARD 1 -i eth1 -j ACCEPT
iptables -I FORWARD 1 -o eth1 -j ACCEPT
??
On 30.8.2009, at 20:47, Peter Peltonen wrote:
> I have a fresh installed CentOS 5.3 server which should route traffic
> between two networks like this:
>
> network A (Internet) -- eth0 (default gw) : server : eth1 -- network
> B (LAN)
>
> I have set in sysctl.conf
>
> net.ipv4.ip_forward = 1
>
> and routing works fine like this. But when I switch on the iptables
> service (with default setup, configured when installing the server),
> routing stops working (or at least I cannot ping a server in network A
> from network B). I guess the firewall is stopping it, so I read
>
> http://www.centos.org/docs/5/html/5.2/Deployment_Guide/s1-firewall-ipt-fwd.html
>
> and issued the commands
>
> # iptables -A FORWARD -i eth1 -j ACCEPT
> # iptables -A FORWARD -o eth1 -j ACCEPT
>
> but that did not help.
>
> So I am asking: what is the correct iptables command to make
> forwarding work?
>
> Regards,
> Peter
> _______________________________________________
> CentOS mailing list
> CentOS@xxxxxxxxxx
> http://lists.centos.org/mailman/listinfo/centos
Hodja Nasredin
nasredin@xxxxxxxx
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
