On Friday 24 April 2009 18:51, Jason Todd Slack-Moehrle wrote:
> How do I add 5900 to the centos firewall? How do I edit the conf file?
I don't know your knowledge so....
Lets go through this step by step.
Commands will be between [].
Examples will be between ''.
You are looking to see why port 5900 is blocked.
Are you sure something is listening on this port?
Check to see if port 5900 is listening with the following:
[lsof -i]
If that port is not listed or if the service is listening on another port you
should see this now. If not then start the service and try to connect again.
Still having issues connecting then we should check the firewall.
First lets see if the firewall is up:
[service iptables status]
If the firewall is up this should give you a list of all the rules present.
If the firewall is not running it will state firewall is not running.
If the firewall is not running, vcn is running and you still cannot connect
the problem is outside your control and you will have to talke with your
service provider. Even if the firewall is running the service provider can
still be blocking the port so after ensureing/configuring the below and you
are still unable to connect you need to contact the service provider and
question them.
If the firewall is running you now have to figure out how it is being started.
Some people use the default method (myself included) and some use scripts
(which I believe is because they do not know how or understand how to
configure the default setup).
First let us check in what run level the system is started.
[grep id: /etc/inittab]
You should see something like
'id:3:initdefault:'
This is run level 3 and all my startup scripts are going to start from
'/etc/rc.d/rc3.d'.
Look in this directory for anything that might be iptables or firewall
related. As stated above some time a script other then the default is used
to start the firewall. Do you see anything other then iptables?
Scripts starting with a 'K' are not run and those with an 'S' are.
We should also check rc.local to ensure there is nothing being started there
that might over ride firewall if it is started in 'rc3.d'.
If you have determined that the firewall is being started the default way and
it is up and running then /etc/sysconfig/iptables is the file you have to
look at and edit. If the firewall is being started using another method then
you are going to have to look at that script to determine how to
correct/update that script.
You can edit the file with 'vim' or 'vi', depending on what is installed on
your system, from the command line.
Here is a link to a very good IPTABLES Tutorial.
http://iptables.rlworkman.net/chunkyhtml/index.html
--
Regards
Robert
Linux User #296285
http://counter.li.org
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
