2009/4/21 Mangesh S. Umbarje <mangesh@xxxxxxxxxxxxxxxxxxxxx>
etc...
Have you tried running with the old kernel from before the update to verify that it doesn't occur with that version?
It is possible that the update is just a coincidence and you are actually facing link problems due to the card, the cable, the switch or any of the connections between...
Dear All,
I am having a HP xw4400 with following ethernet controller
as reported by lspci
Broadcom Corporation NetXtreme BCM5755 Gigabit Ethernet PCI Express (rev 02)
This machine was running CentOS 5.2 without any problem. After
updating the machine with yum update on 8 April, after which it is showing
to be CentOS 5.3, this machine stops communicating intermittantly and I
see the following message correspondingly in /var/log/messages
Apr 18 10:30:07 kernel: tg3: eth0: Link is down.
Apr 18 10:30:10 kernel: tg3: eth0: Link is up at 1000 Mbps, full duplex.
Apr 18 10:30:10 kernel: tg3: eth0: Flow control is off for TX and off for RX.
Apr 18 10:30:24 kernel: tg3: eth0: Link is down.
etc...
The interval for which it happens is about order of few minutes.The
kernel it is running now is 2.6.18-128.1.6.el5. Can anybody help.
Have you tried running with the old kernel from before the update to verify that it doesn't occur with that version?
It is possible that the update is just a coincidence and you are actually facing link problems due to the card, the cable, the switch or any of the connections between...
d
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
