Actually, I have 2 LAN cards. eth0 is working as it is 10/100. There
is a build-in gigalan which doesn't work. I have to remove the 10/100
and make build-in lan works.
[root@localhost ~]# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: d
Current message level: 0x00000007 (7)
Link detected: yes
[root@localhost ~]# ethtool eth1
Settings for eth1:
Cannot get device settings: No such device
Cannot get wake-on-lan settings: No such device
Cannot get message level: No such device
Cannot get link status: No such device
No data available
On Mon, Nov 17, 2008 at 10:54 AM, Barry Brimer <lists@xxxxxxxxxx> wrote:
I have installed Centos completely. However, the LAN doesn't work.
Below is the message after I issue. How can I make it work?
00:19.0 Ethernet controller: Intel Corporation 82567V-2 Gigabit
Network Connection
What does "ethtool eth0" tell you?
What does "ethtool eth0" tell you when the 10/100 card is not installed?
What does "lsmod" look like with the 10/100 card in and out? What does
"dmesg | grep eth" give you with the 10/100 card in and out?
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
