On Tue, Sep 2, 2008 at 5:04 PM, nate <centos@xxxxxxxxxxxxxxxx> wrote:
Paolo Supino wrote:Just to rule it out try plugging in all NICs to the same
> I boot via NIC0 and my configurations are as follows:
> pxe (for node3):
switch/VLAN and kickstart again and see if it works better.
Sometimes the NIC detected as eth0 at PXE time is not the
same NIC as at installation time. My systems typically have
both NICs connected to the same switch(for redundancy using
bonding driver) so I often forget about this issue.
If it works then you can adjust the kickstart config's
ksdevice= option to point to the real NIC your system
will use.
nate
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
Hi Nate
It's a nice thing and I thought of doing it, but it's impractical and here is why: I have 42 systems in this cabinet. Each system as 4 NICs and I only have 1 48 port switch. If I had the additional switches to stack I would have done it a long time ago (and I would have sniffed the network to see where the heck it sending the packets). I checked all the systems that did install successfully (right now stands at 29) and in all of them the MAC address of NIC0 matches the MAC address for eth0 in Linux (which makes sense otherwise the install would have hung up).
--
TIA
Paolo
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
