On Tue, Sep 2, 2008 at 2:17 PM, Romeo Ninov <rninov@xxxxxxxxx> wrote:
Paolo Supino wrote / napísal(a):
Have you check apache logs for something. Check also the server messagesCentOS@xxxxxxxxxx <mailto:CentOS@xxxxxxxxxx> After figuring what I was doing wrong (see previous reply ...) I started going through each of my systems in order to boot them and install CentOS 5.2 on each. For the most part it works, but only for the most part? Because once in a few boots (not machine specific) anaconda stops and either asks me what interface it needs to configure or fails to load 'stage2.img' from the web server on 192.168.11.1 <http://192.168.11.1> ... All cables are good cables. The network switch is a Cisco 3750G with no configuration) and all the NICs are broadcom with firmware 3.8.9. <http://3.8.9.> Can you throw a guess where the problem might be lying (I hate inconsistencies)?
On Tue, Sep 2, 2008 at 8:14 AM, nate <centos@xxxxxxxxxxxxxxxx <mailto:centos@xxxxxxxxxxxxxxxx>> wrote:
Paolo Supino wrote:
> Hi Nate
>
> 3: After the error comes up I get the HTTP setup configuration
screen with
> the source website (in IP) and CentOS directory as I entered
them in the
> pxeconfiguration file and as it appears in the kickstart
configuration file
> and all I have to do is press the 'OK' button to continue the
installation
> to a successful completion.
If that's the case the next most likely culprit is
> url --url http://192.168.11.1/source
Just because the PXE boot loader can download the kickstart
config does not mean that the installation process will work
with that NIC.
Also I've had lots of broadcom systems not work with kickstart over
the years, it's not uncommon for newer systems to have newer
revs of the chipsets and those revs not being supported by the
installer.
But it sounds like in your case it does work, so I would look
at the url above, as it likely is the cause of the problem. Check
the http access logs on the server for 404s and similar errors.
nate
_______________________________________________
CentOS mailing list
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
Hi Romeo
Yes I did, and nothing shows up in either access_log or error_log :-(
I just had a node that stopped asking me for IP configuration (twice) and only on the second time (checked on the server using tcpdump) did it actually try to contact the server to retrieve network configuration continue and it successfully retrieved 'stage2.img' from the web server :-(
--
TIA
Paolo
_______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos
