Dear All,
I have using CentOS 4.4 and My PC USB Drive is detected and
but the device "/dev/sda1" is not initialized and i have executed the
dmesg command and I am getting the following messages
usb 1-6: new high speed USB device using address 2
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: JetFlash Model: TS1GJFV30 Rev: 8.07
Type: Direct-Access ANSI SCSI revision: 02
USB Mass Storage device found at 2
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
SCSI device sda: 1986558 512-byte hdwr sectors (1017 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 1986558 512-byte hdwr sectors (1017 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
sda:
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
and i have tried in windows xp service pack 2 system USB Drive is
detected
but can not opened and i am getting the following message please
insert disk in drive
I am not sure why this is happening. Can some one throw light on this.
Regards
-S.Balaji
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
