Akemi Yagi pisze:
On Sat, Aug 9, 2008 at 12:29 PM, Jancio Wodnik <jancio_wodnik@xxxxx> wrote:
Yahia Tachwali pisze:
to check for hdlc module but I could not find it... I guess I am missing
something to activate my new settings in the menuconfig. Is there a way to
verify that my new settings active!! Does any body know about the HDLC
modules loading in the 2.6.9. Please advise. And thank you all for your
help.
As i remember: hdlc is build not as module, it is core kernel module, not
module to load by modprobe - so in menuconfig is [*] with hdlc not [M] as
module.
But maybe i'm wrong.
Just to expand this a bit...
Go to Device Drivers -> Networking support -> Wan interfaces -> Wan
interface support (y or n only).
In the 'Wan interface support' menu, check 'Generic HDLC layer' (y, n, or M).
Inside the 'Generic HDLC layer', there are a few support options (y or n)
The above layout is for CentOS-5, but CentOS-5 is similar. Hope this helps,
Akemi
you are right, only raw hdlc support and raw hdlc ethernet support are
as [*]. My fault.
Irek
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
