On Thu, 2008-07-31 at 10:08 +0300, Mufit Eribol wrote:
> Hi,
>
> My Centos 5.2 server (5.1 suffered the same problem as well) has a
> logical volume on a RAID 10 array (4 SATA harddisks on a Highpoint
> RR2310 controller). /etc/fstab has an entry for this array as below
> /dev/raid_vg0/raid_lv0 /mnt/raid ext3 defaults 0 0
>
> Normally it works OK. But, file system of "this volume" once in a while
> goes "read only" mode. The RAID software reports no problem with the
> hard disks. After reboot, the system comes back in normal rw mode.
If it happens again, you may be able to avoid the reboot with
mount -o remount,rw /mnt/raid
As to your "how to check production ...", easy. The trade-off (down
time, reboot, ...) makes it easy to decide to knock users down, umount
the FS, run the check, remount, tell users they can go again.
> <snip>
> Mufit
> <snip sig stuff>
HTH
--
Bill
_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos
