Re: Three Identical systems - short cut to setting up the drives?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]



William L. Maltby wrote:
On Fri, 2008-07-04 at 11:41 -0500, Les Mikesell wrote:
<snip>

Yes, dd is actually pretty slow in wall clock time. Where it wins is in human time since you just type a short command line and go away, and it duplicates any setup work you've done in addition too installing the packages.

But it's not as slow as most think. They just don't take advantage of
capabilities, like bs=16384. This makes a *huge* difference in both
system overhead and wall clock time.
Well Clonezilla is busy cloning the drive, but there is a problem here cloning to a USB attached drive.

One of the partitions is LVM and since this is a drive clone, including the partition table and boot sector, both LVMs (source and target) have the same name. So Clonezilla switches to using DD with probably some bad parameters. After running an hour, it has only copied 4Gb out of 37Gb. Note that the USB port is v1.1.


Now actually, I would have perfered renaming the LVM partition and its internal ext3 partitions. I even had a naming convention laid out if I had do this via Install instead.

_______________________________________________
CentOS mailing list
CentOS@xxxxxxxxxx
http://lists.centos.org/mailman/listinfo/centos

[Index of Archives]     [CentOS]     [CentOS Announce]     [CentOS Development]     [CentOS ARM Devel]     [CentOS Docs]     [CentOS Virtualization]     [Carrier Grade Linux]     [Linux Media]     [Asterisk]     [DCCP]     [Netdev]     [Xorg]     [Linux USB]
  Powered by Linux