On Fri, Jun 6, 2008 at 6:51 PM, Ruslan Sivak <russ@xxxxxxxxxx> wrote: > I successfully installed CentOS on 3ware 9650SE controller. Due to some > issues with compatibility with my motherboard, I replaced it with a 9690SA. > Now the system won't boot (although interestingly enough, it find the boot > menu fine, just won't boot past a certain point in the bootup phase. > > I thought I would reinstall, but anaconda doesn't find the raid array. > 3ware does have drivers on their site, but I'm not too sure how to get them > on my system? That controller requires a newer version of the 3ware driver. I'm pretty sure the 5.2 will have that driver. So if you can wait a bit longer... Regards, Tim -- Tim Verhoeven - tim.verhoeven.be@xxxxxxxxx - 0479 / 88 11 83 Hoping the problem magically goes away by ignoring it is the "microsoft approach to programming" and should never be allowed. (Linus Torvalds) _______________________________________________ CentOS mailing list CentOS@xxxxxxxxxx http://lists.centos.org/mailman/listinfo/centos